![]() Be sure to replace X with the actual hard drive letter of the encrypted drive you want to decrypt. In Windows PowerShell window, enter Disable-BitLocker -MountPoint "X:" command and run it. To do that quickly press Windows Key + X to open the popup menu and choose Windows PowerShell (Admin) from the menu. How to Decrypt BitLocker Drive with Windows PowerShell? In this guide, we'll walk you through the steps to decrypt a BitLocker encrypted drive in Windows by using Hasleo BitLocker Anywhere, Windows built-in BitLocker decryption tool, manage-bde.exe and Windows PowerShell. In such case, you have to use Hasleo BitLocker Anywhere, which can help you decrypt the BitLocker encrypted drives in any edition of Windows 11/10/8/7. However, if you are using Windows 11/10/8/7 Home editions or Windows 7 Pro edition, you may not be able to use Windows PowerShell, manage-bde.exe or Windows built-in BitLocker decryption tool to decrypt a BitLocker Encrypted Drive because Microsoft does not provide decryption feature in these editions of Windows. Decrypt BitLocker Drive With Windows PowerShellĪre you looking for a solution to decrypt BitLocker Encrypted Drive in Windows? If you are using Windows 11/10/8/7 Enterprise editions or Windows 11/10 Pro edition, you can use Windows PowerShell, manage-bde.exe or Windows built-in BitLocker decryption tool to decrypt a BitLocker Encrypted Drive. ![]() Decrypt BitLocker Drive With Windows manage-bde.exe.Decrypt BitLocker Drive With Windows built-in BitLocker Decryption Tool.Decrypt BitLocker Drive With Hasleo BitLocker Anywhere.The D: drive seemed stuck at 99.9% encrypted.This tutorial will detail the following methods to decrypt BitLocker encrypted drives in Windows: I did it in a PowerShell window running as administrator. I just had to do one pause resume cycle with manage-bde on my Windows 10 Pro installation. When finished, the drive should be back to its original full size, and the entire drive should still be BitLocker protected: Tell it to reclaim all the unallocated space (screen not shown here). To do this, right-click on the drive you previously shrunk and select "Extend Volume.": You can now return to the Disk Management tool and reclaim the shrunk space. For me, the encryption now ran to 100% and successfully completed: Now return to the BitLocker management window and enable BitLocker again. When finished, the shrunk space will appear as unallocated space to the right of the drive: Tell it how much you want to shrink the volume by (screen not shown here). Right-click on the drive you are trying to enable BitLocker on (in my case it was "C:") and choose "Shrink Volume.": ![]() To bring up the Disk Management tool, press Win+ R then enter diskmgmt.msc: In the end I had access to the full amount of original disk space and BitLocker was fully enabled. I was then able to go back into the Disk Management tool and enlarge the primary partition to reclaim the 40GB of space I had shrunk off earlier. I then enabled BitLocker again and this time it ran until the disk was 100% encrypted and it completed successfully. What finally worked was to use the Disk Management tool to shrink the primary partition by some random number of Gigabytes (I chose to shrink off 40GB). Encrypting only the used space versus the entire disk made no difference either. Telling BitLocker to use the older encryption algorithm versus the newer didn't help. I faced the same situation as the OP.the encryption stage would always get to 99.9% completion and go no further. I purchased a refurbished PC for the office that came with a 446GB SSD as the primary disk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |